Pop-lock PL8525 User Manual download pdf

Step 4: Wiring (there are multiple ways to run the wiring this is one suggestion)

Route the bullet connector side of the short wiring harness through one of the drain holes at the bottom of the tailgate up to the power lock

assembly. Connect it to the bullet connectors of the power unit. Secure the wire with cable ties to prevent the wire from getting pinched

or in the way of the latch rods. Connect the other end to the long wire harness. Locate

this connector under the truck so that it is

accessible for tailgate removal. Run the long wiring cable along the factory wire

harness to under the cab and secure with cable ties.

For 2-Door and Access cab models the wire will be tied into either side kick panel (the plastic cover next to where your feet go). For 4-

Door models the wire can be tied into either side front step plate (the plastic trim along the floor as you step into the truck). Run the wire

into the cab using one of the factory’s rubber

grommets in either the firewall or along the floor pan. Cut a small slit in the grommet or

run the wire next to the grommet to allow the wire to pass through. It is recommended to seal around wire to prevent moisture from entering

the cab. Run the wire out of view and to the place where it is going to get connected. For 2005 and 2006 2-Door models locate the blue and

blue with a white stripe wire. For 2005 and 2006 4-Door models locate the blue and blue with pink stripe wire. For 2007 and up all models

locate the Blue with a black stripe and the blue with light red stripe wire. Use the supplied wire taps to connect to theses two wires. At

this point it doesn’t matter which wire is tapped to the OEM wires. Test the operation of the lock (if the tailgate

lock works opposite of

the door locks, disconnect the two bullet connectors back by the power lock assembly, switch the leads of the wires, and reconnect the

bullet connectors. This will make the lock the same as the doors). Secure all the wiring and replace the removed trim pieces.

Installation

Instructions

Tailgate Lock

PL8525

Toyota Tacoma

2005 – Up

MUST HAVE

PL5400 or PL5500

Technical Support:

Call 1-800-342-5911

technicalsuppo[email protected]

Tools Required: T30 Torx (Star Bit)

10mm Wrench

Step 5: Shut the tailgate. Test the function of the key lock and power lock. If everything works, reinstall the access panel.

Package Contents: Power Lock Assembly

Long and Short Wire Harness

2 Wire Taps, 8 Cable Ties

Instructions

NOTE: Before beginning you must have the PL5400 or the PL5500 Pop and Lock manual locking handle.

Step 1: Remove the T30 Torx screws that hold the access panel on the inside of the tailgate and remove the access panel.

Step 2: Remove the two handle mounting bolts. Install the power lock bracket. You will have to rock the bottom of the handle up to

allow for the power bracket to slide underneath. The plastic toggle post should align in the slot of the power bracket as shown in the

picture. Install the two mounting bolts. You should be able to manually move everything to the lock and unlock position.

1 2

MUST HAVE 1
PL5400 or PL5500 1

Summary of Contents

Page 1 - PL5400 or PL5500

Step 4: Wiring (there are multiple ways to run the wiring this is one suggestion) Route the bullet connector side of the

Page 2

LIMITED WARRANTY TERMS AND CONDITIONS (1) Installation. Pop & Lock™, LLC (and Pop & Lock™ Corporation) is not responsible for installing t

Comments to this Manuals

No comments

Pop-lock PL8525 User Manual

Browse online or download User Manual for For the car Pop-lock PL8525. Pop & Lock PL8525 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Pop-lock PL8525